9mm ar upper and ar15 lower receiver install#
9mm ar upper and ar15 lower receiver plus#

Another rail that I had lying around was the Midwest Industries SP handguard. RAILS: Finding a rail to fit was a little tough (I was originally going to go with a Geissele and machined the anti rotation tabs to get it to fit). When you close the upper, the pin always are perfectly lined up. The fit between them is so tight and precise. I used a Taccom buffer, bolt, and barrel, which worked perfect with this receiver.įIT/FINISH: The receiver is gorgeous. The mag release is a little stiff so I might get their extended one to get more leverage. It’s all tucked inside the lower, like it should be. Everybody else seems to be using the same mechanism that mounts to the outside of the upper receiver not Angstad. The LRBHO worked every time with a range of Glock mags from the G26 to 33 round. All other Glock mags work fine,įUNCTION: I ran 300 rounds to Christen my build and did not have a single issue. If your 33 round has a “-02” instead of “01” in the model number, it may need a simple modification to function. UPS ground shipping to the continental United States is a flat $25.00.PUBLC SERVICE ANNOUNCEMENT: Glock 33 round magazines can have fit issues. Your cost of $525.00 includes one 25, 32, or 40 round magazine and one “all steel & aluminum” mag block made from solid bar-stock, bolt group, charging handle and everything else required for a “drop-in” unit.

9mm ar upper and ar15 lower receiver plus#

You can purchase one of these high quality, very accurate, inexpensive to shoot, 9mm uppers without having to go through a Federaly licensed dealer for $525.00 plus $25.00 UPS shipping anywhere in the continental United States. These are custom built here in the Ten-Ring Precision shop in “very limited” quantities. We have four units cut from 41-40 carbon tool steel. All barrels are threaded with 1/2″ X 28TPI threads that will fit most suppressors.Īll SAMMI specification heat treated are turned from 416 stainless steel bar stock and are absolute the best money can buy. The actual barrel length is 16 1/4″ with a 9mm standard twist of 1:10. However, I have been told some of the lowers made by Colt back around 1982 have a larger front and rear pivot pin so the smaller pins will not work. These 9mm upper units will fit on any “standard” lower. law so CA shooters will have to keep me educated. We can ship magazines to Ca. in pieces as a “kit” or with a mag block which cuts the capacity of a 25 round mag to 10 rounds for a small extra charge of $15.00. Forty round mags are $43.00 when available. Extra 25 & 32 round magazines at this time are $29.00 apiece.

9mm ar upper and ar15 lower receiver install#

All you do is remove your current upper and install the new 9mm upper which comes complete with an “all steel” and aluminum magazine block machined from bar-stock and one 25, 32 or 40 round 9mm UZI magazine altered to work in this unit. Forty round magazines are very limited. All are “hand built units built so you do not have to change the hammer or buffer or make any modifications to your lower receiver.” These top of the line conversions are “recoil operated” and come with beautifully machined and threaded (1/2″ X 28TPI) stainless steel barrels. They have a Picatinny rail flattop in the rear which will allow you to mount a red dot sight of your choosing and shoot inexpensive 9mm ammunition. The field of available dedicated 9mm AR-15 LOWER RECEIVERS is growing at a reasonably fast pace. Complete 9mm AR Upper Conversions For Your AR With Machined Steel/Aluminum Magazine Block ONLY ONE LEFT These 9mm uppers are the highest quality 9mm “drop-in” conversions being sold today.